Finally I bought an Eclipse BEC106 camera on eBay.
Youíll need a soldering iron, silver solder, wire snake, assorted tools and shrink tubing. Youíll also need a cables from an old computer, the ones that connect to the cd-romís audio.
First you need to remove the shifter console. The instructions with some greate pictures can be found this thread
Now remove the AC vents in the middle just above the nav unit. The whole vent unit just pulls out. pay attention to the snap-in pins to be precise about where to pull.
Here is the back of the vents showing the top pins location (white connectors)
Here is the bottom pin location.
The NAV unit is attached with four bolt screws located at the top and the bottom of the unit. In order to reach the top screws you will have to remove the ac vents mentioned above. In order to access the bottom two bolts, you will also need to remove the storage compartment just behind the shifter console shown below.
It is a good idea to move the **** lever all the way back to B gear to get better access. I forgot to do this and had to move the shifter when I got to this step. Then after removeing the two screws on each side, the storage unit will just come out.
Remove the two connectors by squeezing them out. One for the Aux plug and other for the 12V outlet.
After you get this out you can see the bottom two bolts holding the nav unit in place.
BTW, here is a picture of the top two bolts after the vent comes out.
Now, after taking these four bolts out, you are ready to pull the NAV unit out. it just slids out after a little jurk to it.
I did not completely pulled out the nav. Here is pic of what I could see.
The rest to follow in the next post (limit of images forced me to do this)