What about EnnoCar? they can ship at home for 1209$usd for 11 brand new cell.
Anyway review on it?

 

All Chinese cells are inferior to the Panasonic/Sanyo cells. Period. Even compared to healthy ones that are 20+ years old at this point.

There is essentially no warranty if you purchase direct. If you have a problem, all troubleshooting and diagnostics are on you. If a subpack fails, the first claim is that the BCM damaged it. If they concede and offer warranty, they often require you return the failed subpack(s) - which costs notably more than buying a replacement as shipping TO China is very expensive. If they do finally provide warranty, the subpack you get will be new, and likely a bad match for the other subpacks. You will need to recondition the other subpacks to bring them back to the point they perform acceptably paired with a new one.

If you buy from a legit builder, you get a full pack.

 

ok thank.
I’ve look a lot around and did’nt find any other battery builder neer by. they are all in the usa.

I did’nt even found any hch2 of crz to sale neer by. Only option look like scrap the car.

 

So, they did refound me, and give me back an « old » batterie for the coore.
Long story short, the « old » coore was disasembly so they give me an other « good » « rebuild » batterie instead.

Plug it in = ima.
I got home and looking b connector voltage and 3 paires has no voltage.

Open the batterie and saw the little shim plate that it crack. Seem in SS, I was tinking to weld it back, will it work?

I will follow the self discharge of this pack during chrismis, in case by chance that this batterie is good…

thank

 

Insist they replace it with a good one.

 

They have refound me, I will not go back to this shop again.

But instead of giving me a scrap batterie, they give me a supposed good one. Voltage haven’t drop in any subpack overnigh, I’ll continue to monitore it. so maybe this pack will finaly be good…

Only need to repair the 2 shims.

 

Fair enough.

Welding is almost certainly too aggressive and will consume the thin material. soldering may be more viable.

It's usually right here where some hamfisted jacka$$ breaks them:

 

Plan A : buy new part : did’nt found any
Plan B : repair the thing: ain’nt worked
Plan Z : made that shity thing 🤣🤣

 

If it works, it works. Just make sure the bolt is centered, and the pressure is even. Torque to 60 in-lb.