DIY Repair of traction blend door actuator
1 Attachment(s)
At this link: http://www.escape-city.com/viewtopic.php?f=24&t=1229 is a DIY guide for repair of a known issue. There are photos as shown here: Attachment 3101
Can anyone now do this repair and post "real" photos to make the job even easier? |
Re: DIY Repair of traction blend door actuator
1 Attachment(s)
This is a scanguage xguage photo of a normal working traction motor blend door of a 4WD vehicle.
Attachment 3098 |
Re: DIY Repair of traction blend door actuator
I'd be game to tackle this (been getting an intermittent wrench light on my new-to-me 08), but what do I do when I get to step 16?
16. Reprogram the Traction Battery Control Module (TBCM) to the latest calibration using IDS release B52.5 and higher with Patch 7. |
Re: DIY Repair of traction blend door actuator
Originally Posted by Billyk
(Post 214854)
This is a scanguage xguage photo of a normal working traction motor blend door of a 4WD vehicle.
|
Re: DIY Repair of traction blend door actuator
Cool. Thanks Billy. And Carl.
|
Re: DIY Repair of traction blend door actuator
Originally Posted by stevedebi
(Post 214883)
I would think that the code would be the same for FWD as AWD... or do you know differently?
Try it and report back on the findings. |
Re: DIY Repair of traction blend door actuator
Originally Posted by Billyk
(Post 214915)
I hope everyone realizes this information is from Carl (Desert Dog) and not from me. For the 4wd version TXD 076xxxx is used instead of 045xxx.
Try it and report back on the findings. |
Re: DIY Repair of traction blend door actuator
so if i want to check my blend door operation...i just get a scanguage2 ..hook it up and..???? what parameters am i checking? What do other 3 numbers mean...and what is 0000DTC??/ I have 06 mariner hybrid with 138kmiles....and want to make sure things are working properly...i got the dreaded wrench light that went away after next startup....so id like to get SC2 and catch the code sometime
|
Re: DIY Repair of traction blend door actuator
Go to scanguage.com and read up on this piece of hardware that you have to program (input) "numbers" to display information.
|
Re: DIY Repair of traction blend door actuator
Mijohnst, they're suggesting you program an "x-gauge" on a SG2 to read the blend door status.
|
All times are GMT -7. The time now is 12:19 AM. |
© 2024 MH Sub I, LLC dba Internet Brands