new Scanguage software available
#92
Re: new Scanguage software available
[quote=DesertDog;148381]I
Hopefully this xgauge issue with AWDs can be solved with the existing firmware. quote]
I got mine to work correctly. See the file attachment. I was at fault for failing to save the entries correctly.
Hopefully this xgauge issue with AWDs can be solved with the existing firmware. quote]
I got mine to work correctly. See the file attachment. I was at fault for failing to save the entries correctly.
Last edited by Billyk; 11-09-2007 at 05:55 PM. Reason: spelling
#94
Re: new Scanguage software available
I did not proceed correctly in installing new x-gauges. and I need to use the photo on the file attachment to better explain.
-What I did wrong: I was pressing the button by the red arrow when I wanted to input a new x-gauge when the display was still showing an abbreviation and number as reflected by the white arrows. Thus I was inputting one x-gauge over another with inaccurate results. I also failed to save the new inputted x-gauge numeric values at the end.
-How I corrected this: I pressed the button by the blue arrow until there was no abbreviation by a number in the upper right hand side of the display. Then I input the numeric values for each x-gauge.
#95
Re: new Scanguage software available
After talking with Ron at LL, there is not much to try unless he has access to an AWD with non-working battery xgauges. The only thing I can think for users to try is to operate in CAN-sniffer mode, like what is done for the Prius battery voltage.
#98
Re: new Scanguage software available
ScanGauge is located in Mesa, AZ, so I'd guess that Ron is in that vicinity.
I had much earlier tried the different modes as Carl suggested, but not sure if I "Forced" each selection. Might be worth trying that again too.
I had much earlier tried the different modes as Carl suggested, but not sure if I "Forced" each selection. Might be worth trying that again too.
#99
Re: new Scanguage software available
I just noticed that in post #7 the RXF entries did not have the leading zero. I think before they did and this was just an error that crept into the last update. The ScanGauge page has the incorrect RXF also, so hopefully Ron will correct this quickly.