Electric Vehicle Forums

Electric Vehicle Forums (/forums/)
-   HCH II-Specific Discussions (https://electricvehicleforums.com/forums/hch-ii-specific-discussions-51/)
-   -   DIY Oil Change (https://electricvehicleforums.com/forums/hch-ii-specific-discussions-51/diy-oil-change-8204/)

Texas Boy 06-26-2006 02:01 PM

DIY Oil Change
 
I just bought my HCHII two weeks ago. From reading the owners manual, I have the impression that it may be impractical to change the oil in this car myself. Is this the case, or is it really easier than it sounds?

On the off chance it IS practical: is there a synthetic 0W20 available?

ralph_dog 06-26-2006 02:08 PM

Re: DIY Oil Change
 

Originally Posted by Texas Boy
I just bought my HCHII two weeks ago. From reading the owners manual, I have the impression that it may be impractical to change the oil in this car myself. Is this the case, or is it really easier than it sounds?

On the off chance it IS practical: is there a synthetic 0W20 available?

Mobil 1 0W20 is now readily available (back by popular demand) at local retailers including wal mart.

mmrmnhrm 06-26-2006 03:26 PM

Re: DIY Oil Change
 
Changing the oil yourself is do-able, it's just a little more involved than most cars because of the wind shield all along the bottom, and having to remember to go buy a new crush washer at the dealer's. If you've got a small lift plus some stands, you shouldn't have any trouble.

bilbro 06-27-2006 06:22 AM

Re: DIY Oil Change
 
My experience is that Mobil 1 0-20 oil is not "readily available". I've tried to find it at various stores, including WalMart, so far with no success. I'm down to 30% oil life so it's time to get more serious about hunting some up.

spacebug 06-27-2006 06:30 AM

Re: DIY Oil Change
 
Just picked up 12 quarts of Mobil 1 Synthetic 0W20 for my Insight at my local WalMart. Call around to other walmart stores or have a salesperson at your local store call for you to check availablity.

rrunyan 06-27-2006 07:36 AM

Re: DIY Oil Change
 
I had no problem finding Mobil 1 oil.

The only trouble I had was the low front end wanted to scrape against the ramps. A couple of 2 by 6 "spacers" solved that problem.

Ron in SoCal

Mr. Kite 06-27-2006 08:21 AM

Re: DIY Oil Change
 

Originally Posted by rrunyan
I had no problem finding Mobil 1 oil.

The only trouble I had was the low front end wanted to scrape against the ramps. A couple of 2 by 6 "spacers" solved that problem.

Ron in SoCal

I am hoping to change my own oil when the time comes. I have a question--does the oil drain fully when the front end is up? Also, how high does the front end need to be ramped up for access?

Thanks.

spacebug 06-27-2006 08:58 AM

Re: DIY Oil Change
 
I guess the amount of space needed will depend on how big you are. I use 8000 lb Rhino Ramps for my Insight and have no problem with scraping or getting underneath. It's a little tight under there, but no worse than my lowered Audi A8 was!

Added bonus, my local recycling center will take the used oil in washer fluid jugs or similar containers!

Mr. Kite 06-27-2006 09:42 AM

Re: DIY Oil Change
 
Also, many auto parts stores recycle oil. I know the Checker Auto stores in my area do. Of course, when I was growing up, my dad just dumped the oil in a ditch.:omg:

rrunyan 06-28-2006 07:07 AM

Re: DIY Oil Change
 

Originally Posted by Mr. Kite
I am hoping to change my own oil when the time comes. I have a question--does the oil drain fully when the front end is up? Also, how high does the front end need to be ramped up for access?

Thanks.


The "normal" sized ramps are barely adequate. You have to remove the plastic wind gizmo which has 9 clips and 2 screws (if I remember correctly). The wind gizmo goes from the front bumper to about the middle of the car. Not difficult, just cumbersome to deal with. The problem I had was as I started up the ramps the front end wanted to scrape on the ramps because it is so low to the ground. Added the "spacers" just in front of the ramps themselves so the car wouldn't scrape the ramps.

The oil drain plug is at the rear of the oil pan and having the front raised helps get all the oil out.

I reused the crush washer because I was too lazy to go to the dealer for a new one. Next time I'm at the dealer I'll pick up a few for the future. (But I won't be able to find them when the time comes.)

Ron in SoCal


All times are GMT -7. The time now is 09:38 AM.


© 2024 MH Sub I, LLC dba Internet Brands