Gear Knob
#1
01-21-2008, 06:27 PM
Gear ****
Do anybody offer any advice on how can i remove the stock ****?
after removed the lock release button and cover
this how it look like but i fail to locate the next step to remove completely
might wanna change to this look
after removed the lock release button and cover
this how it look like but i fail to locate the next step to remove completely
might wanna change to this look
#2
01-22-2008, 09:45 PM
Ridiculously Active Enthusiast
Join Date: Jul 2007
Location: San Diego, CA, USA
Posts: 941
Re: Gear ****
Hey. I checked my service manual and it's way more complex than I can explain over the internet. PM me with your email and I can send you the diagrams.
#3
01-24-2008, 07:07 PM
Re: Gear ****
thanks for the picture, my manual just arrived
i;m lost how to remove the shroud
it cannot push down or up
wonder if i must remove the lever rod cap and bushing
or the **** two screw first to unplug the ****
unless there's a catch bef the shroud can slide down
i;m lost how to remove the shroud
it cannot push down or up
wonder if i must remove the lever rod cap and bushing
or the **** two screw first to unplug the ****
unless there's a catch bef the shroud can slide down
#5
01-26-2008, 02:42 PM
Ridiculously Active Enthusiast
Join Date: Jul 2007
Location: San Diego, CA, USA
Posts: 941
Re: Gear ****
Yah. The manual did not explain exactly how to take it off. That looks like it will work. Let me know how it goes.
#6
01-27-2008, 04:54 AM
Re: Gear ****
A kind soul like you assisted, I'm redirected to 8th civic forum
From that description and a few attempts, final got the crux of the removal
That guy claimed he pry open both side than pushes down the shroud
I found that prying unnecessary as there’s no locking latch at the side
The only latch that holds the shroud located at the front, but we cannot access there to unlock the shroud so the only alternative location via the rear with a hard thug downwards to release the catch.
Remember to use protective material before place a hard flat metal to force down the shroud, I use a 8mm diameter rod to push down the shroud.
#7
01-28-2008, 02:57 PM
Ridiculously Active Enthusiast
Join Date: Jul 2007
Location: San Diego, CA, USA
Posts: 941
Re: Gear ****
Cool. I'm glad you finally got it off. I want to see what it looks like when you're all done!
Thread
Topic Starter
Forum
Replies
Last Post
Geckoboy
Toyota Camry Hybrid
7
07-13-2013 08:52 AM
Sky Blue
Toyota Camry Hybrid
27
08-15-2008 12:36 AM
